1. Introduction

This series is used for assembly or fit-up of long pipe or tank as wind tower, tank vessel, etc. Adjusting roller UP and DOWN through oil cylinder to gain an accurate alignment of two pipes, and then to weld. It works with conventional type turning roll to realize the section to section assembly by means of “1+1” mode or “1+n” mode (also called growing line). We also provide tailor-made welding rotator according to your special requirements.

2. Main Parameters

          *We reserve the right to alter specifications without prior notice.

3. Main features

The standard models of our roller beds have the following features:

  This welding turning roll consists of unpowered fit-up roller bed, hydraulic unit and electric control system, etc.

  Heat treatment to main welding parts after welding; sand blasting treatment to main welding parts before painting;

  Upper surface of base is treated with fine machining;

  The turning rolls are PU rollers. The core of the rollers are cast-iron clad with PU material

  The four rollers on the turning roll are driven by four oil cylinders separately. It can realize simple operation or simultaneous running at the same side of the two oil cylinders through control, convenient and quick.

  Hand pendant;

  Main electric elements are ABB/Siemens brands;

  Lifting lug on the base of roller bed;

  Standard color:

Optional features:

  Roller material options: Metallic or Rubber roller;

  Interface for integral control with welding column&boom;

  Foot switch;

4. Supply range

  Hydraulic type fit-up turning roll                                                                          1set

  Electric control system [including 1piece of electric control cabinet, 1piece of remote control box with cable 6m]                                                                                                             1set

  Technical documents (with manual book, conformity certificate, packing list, etc)      1set

5. Reference photo